Salter Brecknell 750 Series - Manual (Page 22)

Page C-1
5. The display will momentarily show "SET", followed by a value with one flashing digit.
This value will be the current multiplier value with the decimal point position
programmed above.
6. Use the four directional keys (shown in Figure 4-1 below) to adjust the displayed
value to the actual custom unit multiplier value. Increase the flashing digit by
pressing the UNITS key. Decrease the flashing digit by pressing the ZERO key.
Pressing the PRINT key or the TARE key will change the position of the flashing
digit.
SETUP MODE KEY FUNCTIONS
ZERO
GROSS
NET
TARE PRINT
SET
UNITS
Figure 4-1: Setup Menu Key Assignments
7. After setting the exact value, press the NET/GROSS key to save the custom unit
multiplier value. The display will show "EndCU" momentarily, then revert back up to
F11.