Salter Brecknell 750 Series - Manual (Page 34)

Page C-1
CHAPTER 8: LEGAL FOR TRADE SEALING
8.1 ABS ENCLOSURE
The S750/S750-8 indicator in the ABS enclosure can be sealed for commercial (Legal for Trade)
applications as follows.
1. Power off the indicator by unplugging the power source.
2. On the back of the indicator, locate the Setup/Calibration Slide Switch Cover Plate (see
illustration below).
3. Thread a wire security seal through both drilled head screws securing the calibration
switch cover.
DC Jack Serial Port Connector
LOAD CELL
Setup/Calibration Switch
Figure 8-1: S750/S750-8 ABS Rear Panel
8.2 STAINLESS STEEL ENCLOSURE
Indicators in the stainless steel enclosure can be sealed for commercial (Legal for Trade)
applications as follows.
1. Power off the indicator.
2. On the rear cover of the indicator, locate the calibration switch cover.
3. Thread a wire security seal through both drilled head screws securing the calibration switch cover
as well as the two drilled head screws holding on the rear panel.
Older units
1. Power off the indicator.
2. Locate the two adjacent drilled head screws securing the rear cover.
3. Thread a wire security seal through two drilled head screws securing the rear cover.