BoonDocker POLARIS: 2011-14 PRO RMK 800 - Manual (Page 11)

BoonDocker RMK Turbo
Revised 11/5/2012 Page 11 of 13
www.boondockers.com……………….....
BoonDocker
……….………………....877-522-7805
49. Locate the temp sensor wiring (located in rear of
inner-cooler or in silicone air box) route and plug
into control box harness secure with zip ties.
50.Locate the factory D/C power plug (located in
Velcro pouch on the front of the clutch cover.
NOTE:
Only plug oil pump adapter into the D/C power con-
nector.
Route oil pump power to PWR
51. Install charge tube, (Inner-cooler and Air Box)
Adjust for maximum clearance and tighten clamps
52.Install electronic boost solenoid using Velcro and
zip tie to secure to coolant hose. Route 3/16” line
from brass fitting to top of solenoid .
53. Locate solenoid power connector from the control
box, follow stock wire harness over steering linkage
over to boost solenoid and plug in secure with zip
ties. 54. Route 3/16” line from 90 fitting on boost sole-
noid to the boost actuator on turbo bracket.
NOTE: make sure to use small zip ties on ALL 3/16”
hose connections to prevent blow off..