BoonDocker POLARIS: 2011-14 PRO RMK 800 - Manual (Page 9)

BoonDocker RMK Turbo
Revised 11/5/2012 Page 9 of 13
www.boondockers.com……………….....
BoonDocker
……….………………....877-522-7805
38. Install throttle body adapters, make sure o-ring is
in throttle body groves tighten using supplied spanner
wrench
(NOTE: tighten until compression rings bot-
tom ,do not over tighten)
39.Route fuel line from auxiliary injectors over to
fuel line bracket. Cut and splice into the stock return
fuel line behind the bracket, (
NOTE: splice into the
line that does NOT have the inline fuel filter.)
40. loosen DET sensor bolt to rotate the DET sensor
as shown. Retighten DET sensor bolt, torque to 11-
12 ft lbs. Route wiring and zip tie to throttle body
coolant line.
41. Unplug the lower multi-pin connector from the
ECU, (located on backside of oil tank) Plug the
Boondocker control box in to ECU and stock ECU
harness. 42. Route the Auxiliary injector connectors to throttle
body adapters and plug into Boondocker injectors on
fuel rails. Secure with zip ties