BoonDocker POLARIS: 2011-14 PRO RMK 800 - Manual (Page 12)

BoonDocker RMK Turbo
Revised 11/5/2012 Page 12 of 13
www.boondockers.com……………….....
BoonDocker
……….………………....877-522-7805
55. Install fittings on the waste gate as shown,
Top cap 1-vent and 1-plug . Below Diaphragm 1-
pressure Fitting, and 2–plugs, and leave the n2o ports
empty. 56. Route 3/16” line from the 90 fitting on boost sole-
noid to air fitting on external waste gate on lower
diaphragm .
57. Install Boondocker air intake, If Installing op-
tional cold air intake See steps #59-#62
58. At this time check routing of all fuel lines, all
wiring routing. And all hose routing, zip tie and se-
cure all to prevent rubbing and chaffing.
59.Measure 2” down from the top of the elbow, use
the hose clamp as a guide. Use a sharp razor blade or
saw and cut along the bottom of the clamp.
60. Measure 1/2” back from the top vent as shown
and drill a pilot hole.