Copernicus AUD6-DCS - Manual (Page 11)

10
Attach Built Frame to Plastic Top
Align Legs Assembly with holes in the Plastic Top Assembly
x 4 x 4
Actual Size:
A B
x 4
C
Use 4 holes shown
11
Install Casters
Flip entire Assembly onto its side, so the bottoms
of the Legs are exposed.
Caster x 4
You will need:
(Not to Scale)
Tighten all screws.
!
A
B
B
A
B
A
B
C
C
A
Flip entire Assembly onto its side, so the
bottoms of the Legs are exposed
Press Casters firmly into the Legs
- Casters will click into place
- If necessary, place a wrench between the
wheels & tap in with a rubber mallet.
12
1. Use the iPad mini™ spacer, and set the bottom lip to its minimum position.
Using Dewey with iPad mini™
2. Then slide green piece out to secure iPad Mini™.
Slide the spacer into
the provided slot
Loosen the knob to
slide the bottom lip
into position and then
tighten
1. 2. 3.
1. There is no need for the iPad mini™ spacer, set up the bottom lip to its maximum position.
Using Dewey with 10” iPad®
2. Then slide green piece out to secure iPad®.
1. 2. 3.
Store the spacer under
Dewey’s top mechanism.
Note: To reposition the spacer,
push up, then slide out.
Loosen the knob to
slide the bottom lip
out and then tighten
AUD5-DCS_AUD6-DCS - Version A - 17 December 2014 - Copernicus Educational Products Inc.