Copernicus AUD6-DCS - Manual (Page 4)

1
Attach Headphone Holders to Plastic Top
- Press Headphone Holder down firmly into place. You may need to “wiggle in” the holder so one Side Tab goes
in before the other. NOTE: Headphone Holder may be very hard to snap in because once installed, they are not
meant to be removed.
Repeat for remaining Headphone Holders
Headphone Holder x 6
You will need:
(Not to Scale)
Actual Size:
Plastic Top x 1
Rubber Feet x 4
Align a Rubber Foot with the matching post in the underside of the Plastic Top
- Insert Foot over the outside of the largest inner ring
Repeat for remaining Rubber Feet
FOR AUD5 & AUD5-DCS ONLY:
!
4
1. Use the iPad mini™ spacer, and set the bottom lip to its minimum position.
Using Dewey with iPad mini™
2. Then slide green piece out to secure iPad Mini™.
Slide the spacer into
the provided slot
Loosen the knob to
slide the bottom lip
into position and then
tighten
1. 2. 3.
1. There is no need for the iPad mini™ spacer, set up the bottom lip to its maximum position.
Using Dewey with 10” iPad®
2. Then slide green piece out to secure iPad®.
1. 2. 3.
Store the spacer under
Dewey’s top mechanism.
Note: To reposition the spacer,
push up, then slide out.
Loosen the knob to
slide the bottom lip
out and then tighten
AUD5-DCS_AUD6-DCS - Version A - 17 December 2014 - Copernicus Educational Products Inc.