Coral Industries Provincial Prestige Neo-Angle Swing Door - 846J - Manual (Page 2)

846J 10/02
INSTALLATION INSTRUCTIONS
Cleaning and care of your enclosure is important to its lasting beauty. We suggest using a nonabrasive liquid cleaner.
Never use scouring powder or pads.
CLEANING
Anchors are furnished with every enclosure. However, the use of anchors is not recommended when attaching your enclosure to a fiberglass
unit or wall surrounds with board reinforced mounting areas. Mounting holes in this case should be drilled with a 1/8" drill bit.
Mounting of this unit on tile requires the use of anchors. Special care must be taken not to crack the tile. Before drilling holes in the tile, lightly
chip glazed surface of tile at the desired locations. Drill holes using a 3/16" masonry drill bit. Insert anchors into the holes making certain that
ring on large end of anchor meets the surface of the tile.
USE OF ANCHORS
Before starting installation of your new enclosure, carefully read all instructions
and lay out parts to become familiar with their identity. Installation is a manageable task for an
experienced "Do-It-Yourselfer" and a helper.
Do not try to cut the mirrors or glass used in this enclosure.
Tempered glass and mirrors will disintegrate if cut.
If installation of this enclosure is planned in conjunction with a base and wall surround, make certain
that all installation steps for the base and walls have been completed before installing this enclosure.
Measure and mark a centerline on the top
surface of your base curb using a china
marker. The measurement from the wall
to the intersection of the door and side
centerline is called the wing centerline.
Measure and record each wing centerline.
To determine that this enclosure will fit
your base, measure width of your side
panel. For this enclosure to fit your base,
your wing centerline must be at least
equal to the side panel width plus 1/2";
and at the most side panel width plus
1 3/8".
1
Measure 7/16" from the centerline drawn
in Step 1 toward outside of shower and
draw a Sill Placement Line.
The measurement from the wall to the
intersection of the door and side sill
placement lines will be the wing sill cut
lengths. Measure and record each wing
sill cut length.
2
OUTSIDE OF SHOWER
Left Wing
Centerline
Door
Centerline
Door
Centerline
Right Wing
Centerline
Side Panel Width + 1/2" =
Side Panel Width + 1 3/8" =
Minimum Wing Centerline
Maximum Wing Centerline
Compare with actual measurements:
OUTSIDE OF SHOWER
Centerline
Sill
Placement
Line
7/16"
Left Wing Sill
Cut Length
Right Wing Sill
Cut Length