Coral Industries Provincial Prestige Neo-Angle Swing Door - 846J - Manual (Page 7)

846J 10/02
The use of a caulking compound will assure a watertight seal of your enclosure. Apply caulk along outside
edge of enclosure where metal and shower meet, especially where sill meets threshold.
If desired, caulk inside of enclosure where jambs meet walls.
Magnetic
Door Stop
OUTSIDE OF
SHOWER
Corner
Posts
Hinge Door Stop with
Door Panel attached
Make certain that bottom channel of door is clean and dry before mounting drip rail. After mounting,
drip rail should not be removed or repositioned. Adhesive on tape needs 72 hours curing time for
maximum bond.
Aluminum drip rail may be additionally secured by
drilling with 1/8" drill bit through drip rail into
bottom channel. Attach using 8A x 3/8" truss head
screws. When drilling in door panel, make sure
drill does not hit glass. Glass is seated
approximately 1/2" into channel.
With door in closed position, place drip rail on bottom
channel of door on inside of shower. Position so that
bottom edge of sweep extends approximately 1/2" below
bottom of door.
Mark location for drip rail, peel protective cover from tape
(Q) and press into place.
Insert drip rail plug (S) into groove of drip cap on opening
side of door.
S
Drip Rail
Tape
D
Q
INSIDE OF SHOWER
Drip Rail Plug
1/2"
Sweep extends
1/2" below
bottom channel.
Door
Panel
Drip
Rail
15
16
846J 7/02
Caulk
Caulk joint on opening side of door
where magnetic door stop and sill
meet. On opposite side, caulk
where hinge door stop
and sill meet.
G
Sill
A
Sill
A
Caulk
Caulk
OUTSIDE OF
SHOWER