Coral Industries Provincial Prestige Neo-Angle Swing Door - 846J - Manual (Page 3)

846J 10/02
Join sill parts together at
mitered ends using plastic
gussets (N). Make certain that
ends meet tightly.
Place sill on base curb, sliding sill toward
corner until butt cut ends meet walls. If
necessary for a good fit, file sharp corners of
sill to fit contour of walls.
Mark threshold through pre-punched holes in
sill. Remove sill and drill where marked
using 1/8" drill bit.
Reposition sill on base curb and secure
using 8A x 1 1/4" flat head screws (J).
OUTSIDE OF SHOWER
Sill
8A x 1 1/4"
Flat Head
Screw
File to fit
contour of
your unit.
Door
Sill
A
3
Wing
Sill
A
A
J
N Plastic
Gusset
If anchors are used, mounting
holes should be drilled with a 3/16"
drill bit.
Place jamb (B) against wall with bottom
resting on sill and short legs against wall.
Align jamb vertically using level and mark
wall through pre-punched holes. If
necessary, file back edge (short legs) of
jambs to fit contour of your unit. Repeat for
remaining jamb on opposite side.
Remove jambs and drill where marked using
1/8" drill bit.
Reposition jambs and secure using 8A x 1"
pan head screws (K).
4
5
OUTSIDE OF SHOWER
Sill
8A x 1 "
Pan Head
Screw
A
K
B Jamb
Level
File to fit
contour your
unit.
There are three parts that make up the sill (A) -- a door sill
with two mitered (pointed) ends, and two wing sills, each
with one mitered end and one butt cut (straight) end.
The door sill is sized to fit your door and is not to be altered.
The wing sills are extra long and must be cut to match your
sill cut lenghs recorded in Step 2. Measure each sill, from
the mitered end toward the butt cut end, to the correct length
and cut. (Cut from butt cut end only.)
Mitered End
(pointed end) Butt Cut End
(square end)
Sill
A
Measure
Due to the manufacturing process, there may be rack marks present at one end of your sill and
header. All sills and headers must be trimmed to fit individual openings. When cutting sill and header,
make certain to trim off end with rack marks.