Coral Industries Provincial Prestige Neo-Angle Swing Door - 846J - Manual (Page 6)

846J 10/02
14
When securing header, do not drill through front side of header or hit glass with drill bit.
Glass is seated approximately 1/2" into channel.
Position header over unit and lower
into place.
Join header to jambs by drilling,
from inside shower, through long
leg of header into jambs. Secure
using 8A x 3/8" truss head screws.
Join header to corner posts by
drilling, from inside shower, through
long leg of header into corner posts.
Holes should be 1/2" from corner
joining. Secure using 8A x 3/8"
truss head screws.
Connector Screw
with Washer
M
INSIDE OF SHOWER
Exterior
Handle
M
Interior
Handle
INSIDE OF SHOWER
Door Panel Side Panel
C Header
8A x 3/8" Truss
Head Screw
L
Side Panel
Push / pull handle kit (M) comes with parts assembled
in the order they will be once installed on glass. Loosen
allen screws on interior handle to dissasemble parts.
Place bushings in holes of glass. Trim so that bushings
are flush with glass surface. Place one washer on each
connector screw. From inside surface of glass, insert
connector screw through hole, backing with another
washer on outside of glass. Hold exterior handle in
place on outside of glass and secure by tightening
connector screws.
On inside of glass, slip interior handle over connector
screws. Secure in place by tightening allen screws on
interior handle.
Bushing
Washer
Allen Screw
From inside shower, measure width of door
panel at bottom. Drip rail (D) should be 1/2"
shorter than door width. If longer, cut to proper
length.
Slide vinyl sweep (R) into slot on back of drip
rail. Trim ends even with edges of drip rail.
Smooth cut end of drip rail fin with a file to
remove sharp point.
Drip Rail
Sweep
R
D Drip Rail
Contour
12
13
Measure