Coral Industries 6000 Neo-Angle Swing Door (Traditional) - 846 - Manual (Page 2)

846-GP 12/05
Before starting installation of your new enclosure, carefully read all instructions and lay out
parts to become familiar with their identity. Installation is a manageable task for an experienced
"Do-It-Yourselfer" and a helper.
USE OF ANCHORS
Anchors are furnished with every enclosure. However, the use of anchors is not recommended when attaching your enclosure
to a fiberglass unit or wall surrounds with board reinforced mounting areas. Mounting holes in this case should be drilled with
an 1/8" drill bit.
Mounting of this unit on tile requires the use of anchors. Special care must be taken not to crack the tile. Before drilling holes
in the tile, lightly chip glazed surface of tile at the desired locations. Drill holes using a 3/16" masonry drill bit. Insert anchors
into the holes making certain that ring on large end of anchor meets the surface of the tile.
CLEANING
SEALING
The use of a caulking compound can assure a water-tight seal when applied along outside edge of the enclosure where metal
and bath meet. If desired, caulk inside of enclosure where jambs meet walls.
C leaning and care of your enclosure is important to its lasting beauty. We suggest using a nonabrasive liquid cleaner.
Never use scouring powder or pads.
Do not try to cut the mirrors or glass used in this enclosure.
Tempered glass and mirrors will disintegrate if cut.
KEY DESCRIPTION PART QTY
A SILL A855 3
B JAMB A942 2
C HEADER A101 3
D CORNER POST A930 2
E DRIP RAIL A710 1
F** DRIP RAIL SWEEP ** VS91 1
G* DRIP RAIL TAPE * HT52 1
H MAGNETIC DOOR STOP A954 1
I MAGNETIC STRIP H170 1
J 8A X 3/8 TRUSS HEAD SCREW H470 47
K 8A X 1 1/4 FLAT HEAD SCREW H810 6
L 8A X 1 PAN HEAD SCREW H479 8
N ANCHOR H002 14
O DRIP RAIL PLUG HA28 1
P PLASTIC GUSSET HG45 2
Q METAL GUSSET AG45 2
Z** PULL HANDLE KIT ** HSAD 1
EXTERIOR PULL HANDLE HA32 1
INTERIOR PULL HANDLE HA31 1
6-32 X 1 1/4 PAN HEAD SCREW H485 2
1/8" Drill Bit
3/16" Drill Bit
(3/16" Masonry Bit for
Ceramic Tile)
Measuring Tape
Phillips Screw Driver
File
Drill
Level
China Marker
Caulking Compound
FRAME PACKAGE
PARTS LIST
HARDWARE BAG
* Pre-Installed ** May be Pre-Installed
TOOLS
NEEDED
If installation of this enclosure is planned in conjunction with a base and wall surround, make certain
that all installation steps for the base and walls have been completed before installing this enclosure.