Coral Industries 6000 Neo-Angle Swing Door (Traditional) - 846 - Manual (Page 4)

846-GP 12/05
There are three parts that make up
the sill (A) -- a door sill with two
mitered (pointed) ends, and two wing
sills, each with one mitered end and
one butt cut (straight) end.
The door sill is sized to fit your door
and is not to be altered.
The wing sills must be cut to match
your sill cut lengths recorded in
Step 2. Measure each sill, from the
mitered end toward the butt cut end, to
the correct length and cut. (Cut from
butt cut end only.) Mitered End
(pointed end) Butt Cut End
(square end)
Sill
A
Measure
OUTSIDE OF SHOWER
Centerline
Sill
Placement
Line
7/16"
Left Wing Sill
Cut Length
Right Wing Sill
Cut Length
OUTSIDE OF SHOWER
Left Wing
Centerline
Door
Centerline
Door
Centerline
Right Wing
Centerline
Side Panel Width + 1/2" =
Side Panel Width + 1 1/2" =
Minimum Wing Centerline
Maximum Wing Centerline
Compare with actual measurements:
Measure 7/16" from the centerline
drawn in Step 1 toward outside of
shower and draw a Sill Placement
Line.
The measurement from the wall to the
intersection of the door and side sill
placement lines will be the wing sill
cut lengths. Measure and record
each wing sill cut length.
Measure and mark a centerline on the
top surface of your base curb using a
china marker. The measurement
from the wall to the intersection of the
door and side centerline is called the
wing centerline. Measure and record
each wing centerline.
To determine that this enclosure will
fit your base, measure width of your
side panel. For this enclosure to fit
your base, your wing centerline must
be at least equal to the side panel
width plus 1/2"; and at the most side
panel width plus 1 1/2".
1 Sill
(A)
2 Sill
(A)
3 Sill
(A)