Cj q, Header – Coral Industries 6000 Neo-Angle Swing Door (Traditional) - 846 User Manual
Page 7
846-GP 12/05
8A x 3/8" Truss
Head Screws
Metal
Gusset
Join the three header parts together at
mitered ends using metal gussets (Q).
Make certain that ends meet tightly. Secure
gussets to header using 8A x 3/8" truss head
screws (J).
There are 3 parts that make up the header
(C) - a door header with two mitered ends,
and two panel headers, each with one
mitered end and one butt cut end.
The door header is sized to fit your door and
is not to be altered.
The panel headers must be cut to fit your
measurements. Measure for each panel
header separately.
At the top of unit, measure from the wall to
the center point of each corner post and
record measurements.
Working from the mitered end of right and left
panel headers, measure short leg to the
correct length (recorded in Step 9). Mark and
cut using a hacksaw.
OUTSIDE OF SHOWER
Side Panel
Corner Post
Side Panel
Cut from
flat end
Left
Panel
Header
D
Door Panel
D
B
Jamb
B
Jamb
Left Panel Header
Right Panel Header
C
Right
Panel
Header
C
Cut from
flat end
Measure
and cut
Measure
and cut
Short leg
Short leg
Door
Panel
Header
C
Left
Panel
Header
C
J
Q
Header fits on unit with short leg of
header toward outside of shower.
When cutting header, cut from flat end
only. Do not cut mitered end.
Before measuring for header, make
certain that the corner posts are plumb
and all screws have been tightened.
Measure
from
mitered end
9
Header
(C)
10
Header
(C)
11
Header
(C)