Coral Industries Steam Swing Door/DPNL - 5S3 - Manual (Page 4)

5S3-GP 10/07
Measure width of shower opening at threshold and cut sill
and sill expander
(if used) to that measurement. If necessary,
file corner of sill to fit contour of your unit.
Threshold
Centerline Masking Tape
Sill A
File sharp
corners as
necessary to
fit contour of
your unit
1 Sill
(A)
Due to the manufacturing process, there may be rack
marks present at one end of your sill and header. Sill
and header must be trimmed to fit your individual
opening. When cutting sill and header, make certain to
trim off end with rack marks.
Measure
OUTSIDE OF
SHOWER
OUTSIDE OF SHOWER
Place jamb (B) on sill with short legs against wall. If
necessary, file back edge (short legs) of jamb to fit contour
of your unit.
Align jamb vertically on wall using a level and mark wall
through prepunched holes. Remove jamb and drill where
marked using 1/8" drill bit.
Repeat for remaining jamb.
Sill
File to fit
contour of
your unit if
needed
Jamb B
OUTSIDE OF
SHOWER
Level
8A x 1" Pan
Head Screw
J
A
When anchors (L) are used, holes should be drilled
using 3/16" drill bit. (Use masonry bit for tile.)
3 Jambs
(B)
If using sill expander, snap sill and expander together.
Position sill (and sill expander, if used) on centerline of
threshold with tall edge of sill toward outside of shower.
Tape sill to threshold with masking tape to hold in place
while positioning jambs.
2 Sill
(A)
Sill A
Sill Expander
(Optional) F
Sill
Expander
(Optional)
F
Sill
Expander
(Optional)
F
Measure height of shower opening from threshold to top.
Height measurement determines if sill expander is used.
If height is less than 71 1/2", use sill (A) alone. If opening
is 71 1/2" or more in height, use sill expander (F) along with
sill.