Coral Industries Steam Swing Door/DPNL - 5S3 - Manual (Page 6)

5S3-GP 10/07
If magnetic strips do not seal tightly, re-
verse polarity by removing strip from
door stop and replacing it with the previ-
ous top end as the bottom end.
C Header
Hinge
Door
Stop
OUTSIDE OF SHOWER
Door
Panel
Side
Panel
Position hinge stop, which is attached to door
panel, onto opposite side panel. For safety
purposes, door should be installed to open
out from shower.
9 Hinge Door Stop
Side Panel
Slide magnetic strip (H) into slot on magnetic
door stop (E). Trim ends even with door stop
using scissors.
Choose which will be the opening side of your
door. Door is normally installed to open near-
est to showerhead. Slide magnetic door stop
onto panel on opening side of door. Make
certain that the magnetic strip faces outside of
shower.
Slide vinyl steam seal to rest flush against
magnetic door stop.
8 Magnetic Door Stop
(E)
Insert side panels into wall jambs with bottom
of each panel resting on sill.
Only position side panels at this time. Parts
will be drilled and secured after door is in place
and adjustments have been made for proper
alignment.
7 Side Panels
OUTSIDE OF SHOWER
B
Jamb
Header
C
Vinyl
Steam
Seal
Door is normally
installed to open
nearest showerhead.
Door
Showerhead
Header
Side Panel
OUTSIDE OF SHOWER
C
Magnetic
Door Stop
E
Magnetic Strip
(facing outside
of shower)
Vinyl
Steam Seal
S
H
S