Coral Industries 6000 Swing Door - 463 - Manual (Page 2)

463-GP 5/06
PARTS LIST
A SILL A855 1
B JAMB A942 2
E MAGNETIC DOOR STOP A951 1
G MAGNETIC STRIP H170 1
D DRIP RAIL A710 1
F** DRIP RAIL SWEEP ** VS91 1
H * DRIP RAIL TAPE * HT52 1
J 8A X 1 PAN HEAD SCREW H475 8
K 8A X 3/8 TRUSS HEAD SCREW H470 10
L ANCHORS H002 8
P DRIP RAIL PLUG HA28 1
M** PULL HANDLE KIT ** HSAD 1
6-32 X 1 1/4 PAN HEAD SCREW H485 2
EXTERIOR PULL HANDLE HA31 1
INTERIOR PULL HANDLE HA32 1
DESCRIPTION KEY PART QTY
FRAME PACKAGE
* Pre-Installed ** May be Pre-Installed
HARDWARE BAG
TOOLS
NEEDED
1/8" Drill Bit
3/16" Drill Bit
(3/16" Masonry Bit for
Ceramic Tile)
Pencil
Measuring Tape
Hacksaw
Phillips Screw Driver
Silicone Caulk
File
Drill
Level
Masking Tape
Before starting installation of your new enclosure, carefully read all instructions
and lay out parts to become familiar with their identity.
USE OF ANCHORS
Anchors are furnished with every enclosure. However, the use of anchors is not recommended when attaching your enclosure
to a fiberglass unit or wall surrounds with board reinforced mounting areas. Mounting holes in this case should be drilled with
an 1/8" drill bit.
Mounting of this unit on tile requires the use of anchors. Special care must be taken not to crack the tile. Before drilling holes
in the tile, lightly chip glazed surface of tile at the desired locations. Drill holes using a 3/16" masonry drill bit. Insert anchors
into the holes making certain that ring on large end of anchor meets the surface of the tile.
CLEANING
SEALING
The use of a caulking compound can assure a water-tight seal when applied along outside edge of the enclosure where metal
and bath meet. If desired, caulk inside of enclosure where jambs meet walls.
C leaning and care of your enclosure is important to its lasting beauty. We suggest using a nonabrasive liquid cleaner.
Never use scouring powder or pads.
Do not try to cut the mirrors or glass used in this enclosure.
Tempered glass and mirrors will disintegrate if cut.