Coral Industries 6000 Swing Door - 463 - Manual (Page 5)

463-GP 5/06
Position hinge door stop, which is attached to door panel,
into jamb on opposite side from magnetic door stop. For
safety purposes, door should be installed to open out
from shower.
If magnetic strips do not seal tightly, reverse polarity
by removing strip from door stop and replacing it
with the previous top end to the bottom end.
Hinge Door Stop
(attached to door)
Wall
OUTSIDE OF SHOWER
Jamb B
Door
Panel
Adjust magnetic and hinge door stops until magnetic strip
aligns properly on door panel and door closes evenly at
top and bottom. Once desired alignment of parts has
been achieved, from inside of shower, drill four evenly
spaced holes through leg of jambs (1/4" from edge) into
hinge and magnetic door stops. Secure using 8A x 3/8"
truss head screws (K).
When securing door stops to jambs, do not drill
through front side of jamb.
Jamb
B
Jamb
B
INSIDE OF SHOWER
Door
Panel
Hinge Door Stop
(attached to door)
Magnetic
Door Stop
E
8A x 3/8 "
Truss Head
Screws
1/4"
1/4"
K
6-32 x 1 1/4" Pan
Head Screw
Interior
Handle
Exterior
Handle
OUTSIDE OF SHOWER
Pull
Handle
Kit
Handle for your door may be pre-installed. If so,
disregard this step and continue installation.
M
Mount pull handles, from pull handle kit (L), using
6-32 x 1 1/4" pan head screws provided. Screw heads
should be on the inside of shower.
4 Hinge Door Stop with Door Panel
5 Securing Verticals
6 Pull Handle Kit
(M)