Coral Industries 6000 Swing Door - 463 - Manual (Page 6)

463-GP 5/06
Drip rail may be additionally secured using 8A x 3/8" truss head
screws. When drilling in door panel, make certain drill does not hit
glass. Glass is seated approximately 1/2" into channel.
Clean bottom channel of door before
mounting drip rail. After mounting, do not
remove or reposition. Allow 72 hours
curing time for maximum bond.
P
D Drip
Rail
INSIDE OF SHOWER
Drip Rail Plug
1/2"
1/4" drop from
Opening Side
to Hinge Side
for drainage
Door
Panel
Position drip rail on inside surface of door panel
as described below:
• Side-to-side placement: Edge of drip rail
should be flush with edge of door panel on hinge
side of door.
• Vertical placement: Vinyl sweep should extend
1/2" below bottom of door panel on opening
side. Angle drip rail so that vinyl sweep extends
3/4" below bottom of door panel on hinge side.
This will create an 1/4" slope from opening to
hinge side for water drainage.
Mark position. Remove drip rail from door. Peel
protective cover from tape, and press into place.
Insert drip rail plug (P) into groove of drip rail on
opening side of door.
8 Drip Rail
(D)
Opening Side
Hinge Side
Drip rail flush
with edge of
Door Panel
F Vinyl Sweep
3/4"
Hinge Side
Drip Rail
Sweep
INSIDE
OF SHOWER
Measure
F
D
Drip Rail
Contour
7 Drip Rail
(D)
From inside shower, measure width of door panel at
bottom. Drip rail (D) should be 1/2" shorter than door
panel width. If longer, cut to proper length.
For one-piece vinyl drip rail (V667), continue with next step.
Slide vinyl sweep (F) into slot on back of drip rail. Trim
ends even with edges of drip rail. Smooth cut end of drip
cap fin with a file to remove sharp point.
OUTSIDE OF SHOWER
Hinge Door
Stop
Door
Panel
Sill
Caulk
A
OUTSIDE OF SHOWER
Caulk
Magnetic
Door Stop
A
Sill
Jamb B
E
9 Caulking
The use of a caulking compound will assure
a water-tight seal of your enclosure. Apply
caulk along outside edge of enclosure where
metal and shower meet, especially where sill
meets threshold. If desired, caulk inside of
enclosure where jambs meet walls.
Caulk joint on sill where magnetic door stop
and sill meet. On opposite side, caulk where
hinge door stop and sill meet.