Coral Industries 6000 Swing Door - 463 - Manual (Page 4)

463-GP 5/06
Due to the manufacturing process, there may be
rack marks present at one end of your sill and
header. Sill and header must be trimmed to fit your
individual opening. When cutting sill and header,
make certain to trim off end with rack marks.
Place jambs (B) on sill with short legs against wall. Align
vertically on wall using a level. Mark wall through
prepunched holes. Remove jambs and drill where
marked using 1/8" drill bit.
If necessary, file sharp corners on back of jambs to fit
contour of your unit.
Reposition jambs on wall and secure using 8A x 1" pan
head screws (J).
Contour
as
needed
Jamb
B
Level
Measure opening at threshold of shower and cut sill (A)
to exact measurement. If necessary, file sharp corners to
fit contour of your unit.
Position sill on center of threshold with tall edge of sill
toward outside of shower. Tape sill to threshold with
masking tape to hold in place while positioning jambs.
Threshold
Centerline
Masking
Tape
Sill A
File sharp
corners as
necessary
to fit
contour of
your unit
Sill
A
Centerline
Measure
8A x 1" Pan
Head Screw
J
OUTSIDE OF SHOWER
OUTSIDE OF SHOWER
2 Jambs
(B)
When anchors (L) are used, holes should be drilled
using 3/16" drill bit. (Use masonry bit for tile.)
Slide magnetic strip (G) into slot on magnetic door
stop (E). Trim ends even with door stop using scissors.
Choose side onto which magnetic door stop will be
attached. Door stop is normally mounted in jamb nearest
to showerhead. Slide magnetic door stop into jamb with
magnetic strip facing outside of shower.
Magnetic Strip
(facing outside
of shower)
Magnetic
Door Stop
Jamb
E
G
B
INSIDE
OF
SHOWER
INSIDE
OF
SHOWER
Door Door
Door may be installed to
hinge from either jamb.
3 Magnetic Door Stop
(E)
1 Sill
(A)