Detex VRA-143-D - Manual

Detex Corp, 302 Detex Drive, New Braunfels, Texas 78130 (830)629-2900/1-800-729-3839/ FAX(830)620-6711
E-Mail: [email protected] Internet: www.detex.com
FIGURE 2, TYPE C
Either leaf opens first.
Strike plate installed on VRA door.
Lock on leaf without VRA must be
ECL-230.
FIGURE 1, TYPE B
Active leaf opens both doors.
Overlap plates installed on the inac-
tive leaf.
FIGURE 3, TYPE D
Each leaf is independent.
GENERAL INFORMATION
The VRA-143 vertical rod assembly
is designed for use on double doors
in conjunction with the following
Detex product:
Exit Control Lock Model ECL-
230D.
NOTE
To locate the mounting holes for the
ECL-230's and the VRA, use the tem-
plates provided with these instruc-
tions and disregard the templates
provided with the ECL-230's.
The ECL-230's and the VRA can
be used in any of the three arrange-
ments shown .
Outside Key Control (OKC)
An OKC can be used on the active
leaf of a type 'C' installation.
An OKC can also be used on a type
'B' or type 'D' installation but for
entry only.
INSTALLATION INSTRUCTIONS FOR VERTICAL ROD ASSEMBLY, MODEL VRA-143
DETEX INS143 PAGE 1
FIGURE 4
TOOLS AND SUPPLIES RE-
QUIRED
Center punch to mark hole centers
Hammer
Drill motor and bits
Tape to fasten templates
Tape measure
Screwdriver, blade type
7/8" diameter drill
1" diameter drill
#10-24 tap
EQUIVALENT METRIC
DIMENSIONS
INCHES MILLIMETERS
0.150 4
0.152 4
1/4 6
3/4 19
1 25
1-1/4 32
INS-143/PM April 20, 2007