EFCO S5600 Structural Glazed - Manual (Page 17)

EFCO CORPORATION 7/2012 PART NO. Y306 Page 17 of 28
Series 5600 Silicone Structural Glazed Installation Instructions
Section VI: Glazing Preparation
Installation of Glazing Adaptors at Openings for ¼” Infill
A.) Position vertical adaptor as shown. Place horizontal adaptors between verticals.
Seat adaptors by applying sealant to all four corners.
MIN.
1/
8"
Seal at Captured Glazing Adaptors
Continuously seal gasket
raceway with sealant prior to
installing adaptors.
Cut Formula
Vertical = D.L.O. + 1”
Horizontal = D.L.O. – 1/16”
Note: Vertical adaptors will need a minimum of 1/8”
clearance above joint plug, free FROM sealant.