Elecraft KPA500 Kit Assembly Manual - Manual (Page 10)

9
Install the two rear feet as shown in Figure 5. Note that no lock washers are used and the screws thread into
bushings permanently mounted in the bottom cover.
Figure 5. Installing Bottom Cover Feet.
Check to ensure the tilt stand lies as shown in Figure 5 when it is retracted.
Identify the front edge of the bottom cover. That is the edge that is elevated when the tilt stand is in the
down position.
Note that there is a hole at each corner of the bottom cover. Install a 2D fastener in each corner hole so it
extends off of the front or back edge of the bottom cover as shown in Figure 6. Be sure the 2D fasteners are:
 Mounted on the inside (partially painted) side of the bottom cover.
 Positioned so they extend off of the front and back edges.