Elecraft KPA500 Kit Assembly Manual - Manual (Page 38)

37
Two cable ties are provided to dress the long wires that pass over the transformer. These ties are supplied to
produce a neat arrangement of the wires. They are not required for any safety or operational reason. If you have
not worked with this type of cable tie before, Figure 54 shows the correct way to install them. Install the ties as
shown in Figure 55. After pulling each tie tightly around the wires, cut off the excess where it exits the locking
head. Take care to ensure the yellow, green and red wires can be attached either to the tap terminal on the
rectifier module or to the parking terminals as shown in the figure.
Figure 54. Cable Tie.
Figure 55. Installing Cable Ties.