Environmental Water Systems CWL CHLORAMINE 1865 User Manual
Page 9
9
Installation Instructions - All Systems - Plumbing Connections
INSTALLATION
1.
Turn off gas or electric supply to the water heater(s).
2.
Turn off the main water supply.
3.
Open a hot and cold faucet to drain house water pipes.
NOTE: Keep those hot and cold faucets open until these instructions tell you to close.
4.
Move the system assembly into installation position and check that Valve is securely fastened to the Tank.
CAUTION:
Factory assembly of Valve to Tank connection is performed according to specifications. However
in transportation, delivery and movement to the installation position this connection may have loos-
ened. It is important to make sure this connection is tight and if necessary hand-tighten only in a
clockwise direction to ensure this connection.
NOTE:
System has a self-leveling base which can compensate for any slight floor pitch. Refer to “Instruc-
tions Before Usng” on page 7 and “Where To Install The System” on page 8.
5.a
In the parts bag:
Locate the Bypass Valve and 2 red clips
Connect Bypass Valve to the Valve by inserting male end of the Bypass Valve completely into the Valve body.
Make sure that male end is fully inserted into Valve and only then install the red clips to secure that connection.
CAUTION:
The red clips will break if you attempt to force into position without fully inserting the male end con-
nector into the valve body. If the connector is inserted properly the red clip insertion path will be
clear. Installer is responsible for securing plastic red clips when attaching bypass and adaptors.
To remove red clips simply use pliers and hold tab at top and pull straight up and out.
CAUTION:
Check that all surfaces are clean of any debris before inserting Bypass Valve into valve body.
5.b
In the parts bag:
Locate the 1”, 1 1/4” or 1 1/2” MNPT Adaptors.
Select the proper sized Adaptor for your incoming/outgoing water lines and connect the Adaptors to the supplied
Bypass Valve.
NOTE: 1” adaptors with red clips may already be inserted for shipping purposes. This is also the most common line
size. Flow rate to system is determined by the incoming line size. If needed, select and use proper adaptor
(1”, 1-1/4”, or 1-1/2”) for the main line size that the system is being installed on.
If needed, to remove red clips simply use pliers and hold tab at top and pull straight up and out.
CAUTION:
The red clips will break if you attempt to force into position without fully inserting the male end con-
nector of Adaptor into the Bypass. If the connector is inserted properly the red clip insertion path will
be clear. Installer is responsible for securing plastic red clips when attaching bypass and adaptors.
CAUTION:
Check that all surfaces are clean of any debris before inserting Adaptor into Bypass Valve.
WARNING:
Make sure on the Bypass Valve both Inlet and
Outlet Valves are in the bypass position
NOTE:
When Inlet and Outlet Valves are in the bypass
position the holes appear at the top and bottom
as shown in the illustration to the right.
Valve
in Bypass
Outlet
Inlet
Valve
in Bypass
Inserted Adaptors
for Water Line
Connections
Insert Connections
into Valve Body
Illustration of Bypass Valve in the bypass position
Top View