Environmental Water Systems DWS-UV - Manual (Page 6)

6
www.ewswater.com O: 702.256.8182; M-F 8:30am-4:30pm PST E: [email protected]
Installation of the Supplied Dispenser/Faucet
Below the Surface
Step 5:
Insert white beveled washer, bevel side up to fit snugly
into a (1 3/8”) pre-drilled hole or flat side up depending
on the application
Step 6:
Place lock washer on this white beveled washer
Step 7:
Spin hex nut onto faucet stem and tighten
hex nut and washers into place
Step 8:
Slide 1/4” compression nut (threads up) onto 1/4” filtered line
Step 9:
Slide 1/4” plastic compression ferrule, long side down onto filtered
water tube. Ferrule will seat into compression nut
Step 10:
Insert 1/4” tube insert sleeve into 1/4” filtered water line
Step 11:
Insert 1/4” blue (filtered water) tube into faucet stem. Leave other end
available for system interconnection
Step 12:
Thread 1/4” compression nut onto faucet stem and tighten
CAUTION: Do not overtigthen fittings
Above the Surface
Step 2:
Place decorative washer to bottom of faucet body
(optional: place flat white washer under decorative washer)
Step 3:
Place black rubber washer below decorative washer
(or below optional flat white washer)
Step 4:
Place faucet stem through hole and center
Note: Spout pulls out from faucet body and has 2 o-rings at base. Insert completely into bottom of faucet body to prevent
leaking. Spount swivels to direct water. Handle and tip can be removed. Handle can be locked up in open position.
** Other faucets check with specifications. ***All dimensions are approximate.
Enclosed Dispenser/Faucet Dimensions***
Height: from deck to top of dispenser 8”
from deck to tip of dispenser 6 1/4”
Reach: from center of dispenser to tip 6”
Hole: minimum required 1/2”
maximum 1 3/8”
Step by step instructions to mount and secure the supplied dispenser/faucet
If using another faucet, please review the instructions included with that product**
Step 1: Locate Faucet Parts Bag
Parts Included:
faucet body with handle, faucet spout with tip, decorative washer,
black rubber washer, white beveled washer, lock washer, hex nut,
1/4” tube insert sleeve, 1/4” plastic compression ferrule,
1/4” compression nut
Optional Part: flat white washer
(for use under decorative washer depending on hole/application)