Environmental Water Systems DWS-UV - Manual (Page 7)

7
www.ewswater.com O: 702.256.8182; M-F 8:30am-4:30pm PST E: [email protected]
Placement/Where to Install the Water System
Simply place the water system on a level floor, cabinet bottom or horizontal surface.
Always assume for enough space and tubing to remove, move and/or adjust the system
for filter replacement and maintenance.
If mounting the system to a wall, cabinet side or other vertical surface, a minimum clearance of 4” will be required to allow for
filter replacement. Please see the following procedures:
Step 1
All filter cartridges for the system are included. For Model # DWS-UV only, UV Lamp and Housing are pre-installed.
Locate the 3 filter cartridges. Starting from the left or “FEED” side, Stage 1 insert the blue labeled pre-sediment filter, next
Stage 2 insert the orange labeled pre-filter and lastly Stage 3 insert green post-filter.
Inserting the filter cartridge:
At the blue top of each filter cartridge find the side with two (2) notches. Line the notches up and insert filter cartridge into
the filter head assembly. Once cartridge is fully inserted into the head turn clockwise and completely lock into position.
NOTE: Water flows from Left (Labeled: FEED) to Right (Labeled FAUCET)
Filters (by color) from Left to Right: Blue, Orange, Green
Step 2
Once filter system has been fully assembled, mark pilot holes using the bracket as a template.
Step 3
Using a drill bit or punch, drill a hole or punch as a starter hole to catch the mounting screws.
WARNING: ALTERNATIVE FASTENING METHOD MAY BE REQUIRED FOR PLASTER BOARD, PARTICLE BOARD OR SIMILAR MATERIAL
INSTALLATION. USE SAFETY GLASSES OR OTHER EYE PROTECTION TO PREVENT POSSIBLE EYE INJURY DUE TO FLYING PARTICLES.
Step 4
Set mounting screws (provided) with screw driver. Leave a 1/4” gap between the screw head and mounting surface to allow
the bracket to slide on easily.
Step 5
Slide the bracket over the screws and hang the unit. Make sure unit is level. Now make the connections of tubing to/from the
system.
Helpful Hint:
Take a note of the Model # for the required
warranty registration of this unit. This Service
Guide will come in very handy when it’s time
for filter replacement.
Kitchen Faucet
Dispenser/Faucet of
filtered water
Inlet from
Cold
Inlet/Supply
Connection
(angle stop
not shown)
strictly for illustration purposes only
Unit Mounted to Wall (option shown) or
Placed on level floor
Please Note:
Water flows from Left (Labeled: FEED)
to Right (Labeled FAUCET)
Filters (by color) from Left to Right:
Blue, Orange, Green