Environmental Water Systems DWS-UV - Manual (Page 9)

9
www.ewswater.com O: 702.256.8182; M-F 8:30am-4:30pm PST E: [email protected]
Step 1
This system may have come with sample plugs. If so, please remove correctly by following instructions below before
installation.
WARNING:
NEVER ATTEMPT TO REMOVE TUBING OR SAMPLE PLUGS BY JUST PULLING.
Follow simple instructions illustrated below to remove properly.
INSPECT:
Inspect the fitting for any damage from shipping, handling and/or delivery. STOP, if collet is damaged in any way; call, fax or
e-mail customer service for a replacement fitting.
Step 2
Make the Connections from Unit to Inlet/Supply Connection
Connect the orange/red tubing from the installed Inlet/Supply Connection to the location on the unit labeled “FEED” to the
left of Stage 1. This is the raw supply water into the system. Insert and press the tubing firmly and completely into the fitting.
Step 3
Make the Connections from Unit to Faucet/Dispenser
Connect the blue tubing from the installed Dispenser/Faucet to the location on the unit labeled “FAUCET” to the right of
Stage 3. This is the filtered water line. Insert and press the tubing firmly and completely into the fitting.
WARNING:
Install with the “FEED” (in) and “FAUCET” (out) as labeled. Make sure never to reverse directions.
Never Pull Tube Out
To Remove
Push Collet In
To Release
To Insert, Press Tubing In
Firmly and Completely
Make sure tubing end is
straight and not flattened
Connection of Tubing from Supply and to Dispenser/Faucet
CAUTION:
Always leave the tubing provided to allow lifting the unit for filter replacement and maintenance.Make sure tubing has gentle
curves. Roll and secure as needed. Do not bend or kink tubing. We do not recommend shortening the tubing, however, If
needed, at end, cut tube straight and do not flatten. Avoid any tubing contact to hot water line.
WARNING:
NEVER ATTEMPT TO REMOVE TUBING BY JUST PULLING. Follow simple instructions illustrated above to remove properly.
INSPECT:
Upon installation, inspect the connection and give the tubing a gentle “tug” to insure proper connection and integrity of the
fitting.
Inspect the fitting for any damage from shipping, handling, delivery, and/or installation.
STOP, if collet is damaged in any way; call, fax or e-mail customer service for a replacement fitting.
Test Integrity of Fitting:
Give a Gentle “Tug”
To Insure Proper
Connection
See All Cautions,
Warnings and
Inspections