ETS-Lindgren 2090 Controller - Manual (Page 158)

Appendix C: Model 2090 Error Code Reference Model 2090 Multi-Device Controller
SYSTEM TEST FAILURES:
that service is needed. In the event of such an
back on. If the error recurs, contact ETS-Lindgren for
service.
E100 ROM test error: ROM has been detected as being
corrupt.
The following errors are of a more serious nature and may
indicate
error, power off the unit for several seconds and power it
E101 RAM test error: RAM
corrupt. has been detected as being
E102 NVM test error: NVM has been detected as being
corrupt.
E103 Low Power Test error: Power test failed.
E104 GPIB Test error: GPIB test failed.
HARDWARE ERRORS:
The following errors are not limited to the startup process,
and should not occur under normal operation. In the event
of such an error, power off the unit for several seconds and
power it back on. If the error recurs, contact ETS-Lindgren
for service.
E996 BERR Error
E997 Uninitialized Interrupt
E998 Spurious Interrupt
E999 Invalid Interrupt Error
TROUBLESHOOTING ERROR CODES
Error codes E001 - E007 may be cleared by pressing any
key and correcting the reported condition. The errors
E100 - E104 and E996 - E999 should be recorded and noted
as to what action brought about the error. If resetting the
machine does not clear the error and allow normal
reported to ETS-Lindgren for operation, the error should be
prompt attention.
158 © ETS-Lindgren– April, 2006
Revision G– P# 399199