ETS-Lindgren 2090 Controller - Manual (Page 36)

Preparation for Use Model 2090 Multi-Device Controller
GPIB INTERCONNECTIONS
The Model 2090 is compatible with the General Purpose
Interface Bus as described in the IEEE 488.1/488.2
standard. A "D" connector has been provided on the 2090
rear panel for connection to a GPIB bus.
NOTE: When making this connection, do not stack more
than three cables on any one connector. This eliminates
undue mechanical stress on the connector and rear panel.
Also, be sure to screw the two-connector lock-screws finger
tight to avoid a loose connection during operation.
NOTE: The controller's talker/listener bus address can be
set through the front panel. Instructions on how to perform
this operation may be found in “Initialization” under the
subsection “Configuring For Use”.
36 © ETS-Lindgren– April, 2006
Revision G– P# 399199