ETS-Lindgren 2088 EuroPro Electric Powered Turntable - (Archived 03/31/10) - Manual (Page 23)

MODEL 2088 ELECTRIC POWERED TURNTABLE Operation
© ETS-LINDGREN L.P. – JANUARY 2003 19
REV C – PN 399253
Then the “current position” button is pressed to get back to
operation mode.
The table is rotated from 0 to 360 and the mark is now within one
degree of being one full turntable revolution. Calibration is
complete.
SETTING CURRENT POSITION ON 2090
The Model 2088 Turntable is not equipped with mechanically
actuated or “hard” limit switches. The stopped position of the
turntable platform at 0 degrees may drift overtime depending on
usage. The platform can be rotated periodically back to a desired
position and the 2090 current position can be reset to 0.
To check the current position of the turntable on the Model 2090,
press the CURRENT POSITION key under LIMIT. The indicator
above this key will light and the device’s current position will
appear on the display.
To change the current position setting on the Model 2090, press the
CURRENT POSITION button then the INCRM or DECRM
buttons to select the new setting. Press the ENTER button to save
the new setting.
The “soft” travel limits (CW and CCW) on the 2090 will continue
to function and may need to be reset to accommodate the new
current position setting.
NOTE: The current position cannot be changed to a value greater
than the upper limit or less than the lower limit.
CHANGING ROTATION SPEED
The Model 2088 Turntable is equipped with a variable speed drive.
Firmware Revision 3.01 (or higher) must be installed in the Model
2090 Controller for proper operation of the Model 2088. The
revision level is displayed on the front panel LED display during
startup of the Model 2090 Controller. If the controller does not
Archived 3/31/10