ETS-Lindgren 2088 EuroPro Electric Powered Turntable - (Archived 03/31/10) - Manual (Page 6)

Standard Configuration MODEL 2088 ELECTRIC POWERED TURNTABLE
2 © ETS-LINDGREN L.P. – JANUARY 2003
REV C – PN 399253
STANDARD CONFIGURATION
• Turntable Assembly
• Single-phase electric drive (208-230 VAC 50/60 Hz)
• Variable speed drive
• Conductive top
• Continuous rotation
• Ten meter fiber-optic control cables (standard)
MODEL 2088 OPTIONS
Model 2090 Positioning Controller: This controller provides
control for two separate devices (EMCO towers and turntables) in
any combination, plus the control of four auxiliary devices. The
unit includes a GPIB bus and is compatible with most popular
software. (Firmware revision 3.01 or higher required.)
Ground Plane Interface
1
: This interface is a square section of
conductive flooring which has a pre-cut opening for the turntable.
As a result, the difficult process of cutting a perfect diameter hole
for the turntable is eliminated. The square edges of the interface
connect to the chamber flooring using framing elements which
provide a uniform and consistent clamping action. A pre-mounted
ground ring is included with the interface. Together with the
EuroPro’s continuous brush system, they provide continuity with
the ground plane.
Shield Room Feed-Through: This option allows the customer to
take the fiber-optic control cable from the control room to the
shield room and still maintain shielding attenuation. The unit is
made of brass for conductivity and provides attenuation of greater
than 100 dB at 10 GHz. A single 22.25 mm (.875") hole is
required to mount this option.
Additional Fiber Optic Cable: Additional lengths of fiber optic
cable may be ordered.
1 European manufactured models include ground plane interface.
Archived 3/31/10