ETS-Lindgren 2088 EuroPro Electric Powered Turntable - (Archived 03/31/10) - Manual (Page 27)

MODEL 2088 ELECTRIC POWERED TURNTABLE Recommended Maintenance
© ETS-LINDGREN L.P. – JANUARY 2003 23
REV C – PN 399253
RECOMMENDED MAINTENANCE
CAUTION: Do not perform maintenance while turntable is
operating. Disconnect the power connection for safety.
Regular maintenance will prolong the serviceable life of your
turntable. Follow this recommended schedule.
EVERY SIX MONTHS
Grease the casters. Use a good quality bearing grease to lubricate
the casters.
Inspect the ground brush for contaminates. Vacuum the brush to
remove unwanted debris. Add a small amount of conductive
lubricant to the brush interface if required.
Inspect the ground brush for wear. A well maintained ground brush
should have a long serviceable life. Should it need to be replaced,
replacement ground brushes for turntables are available in standard
lengths that are straight and not trimmed. They are assembled at
the factory into the predrilled aluminum extrusion that is attached
around the edge of the turntable. During replacement the brush
assembly is clamped in place using a pipe clamp in order to bend
the brushes to conform to the edge of the turntable top. The
replacement brushes have hole spacing that is machined exactly
the same as the original.
EVERY 12 MONTHS
Lubricate the main bearing race. Use a grease gun with a good
quality bearing grease. The grease fittings are located inside the
race, 90 degrees apart, underneath the top. Three discharges from
the grease gun in each fitting are adequate.
Grease the gear teeth. Apply a good quality grease to the gear
teeth.
Archived 3/31/10