Jeep 2004 Grand Cherokee User Manual

Page 33

Advertising
background image

Rear Center Lap Belt

The rear center seating position has a lap belt only. To
fasten the lap belt, slide the latch plate into the buckle
until you hear a “click.”

To lengthen the lap belt, tilt the latch plate and pull. To
remove slack, pull the loose end of the webbing. Wear the
belt snug against the hips. Sit back and erect in the seat,
then adjust the belt as tightly as is comfortable.

WARNING!

A lap belt worn too loose or too high is dangerous.
A belt worn too loose can allow you to slip down

and under the belt in a collision.

A belt that is too high will apply crash forces to

the abdomen, not to the stronger hip bones. In
either case, the risk of internal injuries is greater.
Wear a lap belt low and snug.

Enhanced Driver Seat Belt Use Reminder System
(BeltAlert)

If the driver’s seat belt has not been buckled within 60
seconds of starting the vehicle and if the vehicle speed is
greater than 5 mph (8 km/h), the Enhanced Warning
System (BeltAlert) will alert the driver to buckle their seat
belt. The driver should also instruct all other occupants to
buckle their seat belts. Once the warning is triggered, the
Enhanced Warning System (BeltAlert) will continue to
chime and flash the Seat Belt Warning Light for 96
seconds or until the driver’s seat belt is buckled. The
Enhanced Warning System (BeltAlert) will be reactivated
if the driver’s seat belt is unbuckled for more than 10
seconds and the vehicle speed is greater than 5 mph (8
km/h).

The Enhanced Warning System (BeltAlert) can be en-
abled or disabled by your authorized dealer or by
following these steps:

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

33

2

Advertising