Canon 1D X - Manual (Page 166)

166
d: Program AE
The focus confirmation light <o> blinks and focus is not
achieved.
Aim the center of the Area AF frame over an area with good contrast,
then press the shutter button halfway (p.46). If you are too close to the
subject, move away and try again.
Sometimes multiple AF points light up simultaneously.
All those AF points have achieved focus. As long as the AF point
covering the desired subject lights up, you can take the picture.
The focus confirmation light <o> does not light up.
In the AI Servo AF mode, it indicates that the camera is focusing
continuously on a moving subject. (Although the AF status indicator
<i> is displayed, the focus confirmation light <o> does not light up.)
Note that focus lock (p.67) will not work in the AI Servo AF mode.
Pressing the shutter button halfway does not focus the subject.
If the focus mode switch on the lens is set to <MF> (Manual Focus), set it
to <AF> (Auto Focus).
The shutter speed and aperture displays are blinking.
Since it is too dark, taking the picture may result in a blurred subject due
to camera shake. Using a tripod or a Canon EX-series Speedlite (p.190)
(sold separately) is recommended.
When flash was used, the bottom part of the picture came out
unnaturally dark.
If a hood is attached to the lens, it can obstruct the flash coverage. If the
subject is close, detach the hood before taking the picture with flash.
FAQ
COP
Y