Cisco 2600XM Series - Manual (Page 14)

14
Step 3 Attach the ground lug or ring terminal to the chassis as shown in Figure 10 or Figure 11. For the ground lug, use the
two screws with captive locking washers provided. For a ring terminal, use one of the screws provided. Use a number 2
Phillips screwdriver, and tighten the screws to a torque of 8 to 10 in-lb (0.9 to 1.1 N-m).
Figure 10 NEBS-Compliant Chassis Ground Connection Using Ground Lug
Figure 11 Chassis Ground Connection Using Ring Terminal
Step 4 Connect the other end of the ground wire to a grounding point at your site.
4
Connect Cables
Warning Do not work on the system, or connect or disconnect cables during periods of lightning activity. Statement 1001
Warning Before opening the chassis, disconnect the telephone-network cables to avoid contact with telephone-network
voltages. Statement 1004
System Management Connections
The connections described in Table 1 provide system management access.
Table 1 System Management Connections
Port Color Connected To: Cable
Console Light blue PC or ASCII terminal communication port (usually labeled COM) RJ-45-to-DB-9 adapter cable
Auxiliary Black Modem for remote access RJ-45-to-DB-25 adapter cable
SEE MANUAL BEFORE INSTALLATION
SERIAL 1
SERIAL 0 CONN CONN WIC 2A/S
SEE MANUAL BEFORE INSTALLATION
SERIAL 1
SERIAL 0 CONN CONN WIC 2T
Cisco 2611 100-240V– 1A 50/60 Hz 47 W
W0
AUX CONSOLE ETHERNET 0 ACT LINK ACT ETHERNET 1 LINK
W1
36454
Ground lug
103057
SEE MANUAL BEFORE INSTALLATION
SERIAL 1
SERIAL 0 CONN CONN WIC 2A/S
SEE MANUAL BEFORE INSTALLATION
SERIAL 1
SERIAL 0 CONN CONN WIC 2T
Cisco 2611 100-240V– 1A 50/60 Hz 47 W
W0
AUX CONSOLE ETHERNET 0 ACT LINK ACT ETHERNET 1 LINK
W1
Ring terminal