Kontron CP6002 - Manual (Page 33)

CP6002 Introduction
ID 1036-6431, Rev. 3.0 Page 1 - 13
P R E L I M I N A R Y
Chi
ps
et
Intel® QM57 Mobile Intel® QM57 Express Chipset:
• One x4 and four x1 PCI Express 2.0 ports operating at 2.5 GT/s
• SATA host controller with six ports, 3 Gbit/s data transfer rate and
RAID 0/1/5/10 support
• USB 2.0 host interface with up to 14 USB ports available (only six ports
are used on the CP6002)
• SPI Flash interface support
• Low Pin Count (LPC) interface
• PCI interface, 32-bit/33 MHz (not used on the CP6002)
• Power management logic support
• Enhanced DMA controller, interrupt controller, and timer functions
• System Management Bus (SMBus) compatible with most I²C™ devices
• DMI and FDI interfaces to the processor
• High Definition Audio (HDA) interface
• Analog display port
• Three digital display ports
• Integrated RTC
Integrated Controller
Graphics controller High-performance 3D graphics controller integrated in the processor:
• Supports resolutions up to 2560 x 1600 pixels @ 60 Hz
• Support for two independent displays
• Dynamic Video Memory Technology (DVMT)
Inte
rfaces
CompactPCI Compliant with CompactPCI Specification PICMG 2.0 R 3.0:
• System controller operation
• 64-bit / 66 MHz PCI or PCI-X master interface with dedicated PCIe-to-
PCI-X bridge
• 3.3V or 5V signaling levels (universal signaling support)
Compliant with the Packet Switching Specification PICMG 2.16.
When installed in a peripheral slot, the CP6002 is isolated from the CompactPCI
bus. It receives power from the backplane and supports rear I/O and, if the system
supports it, packet switching (in this case up to two channels of Gigabit Ethernet).
Rear I/O The following interfaces are routed to the rear I/O connector J3, J4 and J5:
• COM1 and COM2 (RS-232 and RS-422 signaling); no buffer on the rear
I/O module is necessary
• 4 x USB 2.0
• 1 x CRT VGA, 2 x HDMI/DVI (with HDCP 1.4 support)
• 1 x HDA
• 2 x Gigabit Ethernet (compliant with PICMG 2.16, R 1.0)
• 4 x SATA
• 1 x rear I/O interconnection to PMC/XMC slot A
• 2 x GPIOs (on request)
Table 1-2: CP6002 Main Specifications (Continued)
FEATURES SPECIFICATIONS