Introduction cp6002 – Kontron CP6002 User Manual
Page 36
Introduction
CP6002
Page 1 - 16
ID 1036-6431, Rev. 3.0
P R E L I M I N A R Y
Switches
DIP Switches
Three onboard DIP switches, SW1, SW2, and SW3, for board configuration
Reset Switch
One front panel hardware reset switch
Hot Swap Switch
One switch for hot swap purposes integrated in the front panel handle in
accordance with PICMG 2.1 Rev. 2.0.
LEDs
System LEDs
System Status LEDs:
•
I0/I1 (green):
Indicate the software status of the IPMI controller
•
WD (green):
Watchdog Status
•
TH (green):
Temperature Status
•
HS (blue):
Hot Swap Control
Debug LEDs:
•
DLED0-3:
Onboard LEDs for debugging purposes
(located on the rear side of the board)
Ethernet LEDs
Gigabit Ethernet Status on CP6002-R1:
•
ACT (green):
Ethernet Link/Activity
•
SPEED (green):
Ethernet Speed
Gigabit Ethernet Status on CP6002-R1-MC and CP6002-R2-MC:
•
ACT (green):
Ethernet Link/Activity
•
SPEED (green / orange/off):
Ethernet Speed
Ti
m
er
Watchdog Timer
•
Software-configurable, two-stage Watchdog with programmable timeout
ranging from 125 ms to 4096 s in 16 steps
•
Serves for generating IRQ or hardware reset
System Timer
•
The Intel® QM57 chipset contains three 8254-style counters which have
fixed uses
•
In addition to the three 8254-style counters, the Intel® QM57 chipset in-
cludes eight individual high-precision event timers that may be used by
the operating system. They are implemented as a single counter each
with its own comparator and value register.
IP
MI
Baseboard
Management
Controller
•
NXP® ARM7 microcontroller with redundant 512 kB Firmware Flash and
automatic roll-back strategy
•
The BMC carries out IPMI commands such as monitoring several on-
board temperature conditions, board voltages and the power supply sta-
tus, and managing hot swap operations.
•
The BMC is accessible via two IPMBs (through the J1 and J2 connec-
tors) and one host Keyboard Controller Style (KCS) interface.
Thermal Management
CPU and board overtemperature protection is provided by:
•
Temperature sensors integrated in processor:
•
Two temperature sensors for monitoring the processor cores
•
One temperature sensor for monitoring the graphics controller and
the memory controller
•
One temperature sensor integrated in the Intel® QM57 chipset for mon-
itoring the chipset
•
One onboard temperature sensor for monitoring the board temperature
•
Specially designed heat sinks
Table 1-2:
CP6002 Main Specifications (Continued)
FEATURES
SPECIFICATIONS