Kontron CP6002 - Manual (Page 35)

CP6002 Introduction
ID 1036-6431, Rev. 3.0 Page 1 - 15
P R E L I M I N A R Y
Interfaces
Mass Storage CompactFlash (CP6002-R1 and CP6002-R1-MC):
• CompactFlash socket for type I and II CompactFlash cards (DMA
capable true IDE mode)
• The CompactFlash is always configured as IDE master
• The CompactFlash interface is realized via a SATA-to-PATA bridge
One Serial ATA interface for:
• Up to 32 GB Flash memory via an onboard Serial ATA Flash module
(SSD), or
• Onboard 2.5" hard disk drive (HDD) or solid state drive (SSD) is
supported via the SATA extension connector, J19, in combination with
the CP6001-EXT-SATA module
Integrated Serial ATA Host Controllers:
• Provide support for independent DMA operation on six ports
• Data transfer rates up to 300 MB/s
• High-performance RAID 0/1/5/10 functionality on all SATA ports
Sockets
Front Panel Connectors CP6002-R1:
• VGA: 15-pin, D-Sub connector, J12
• USB: two 4-pin, type A connectors, J6 and J7
• Ethernet: two 8-pin, RJ-45 connectors, J10 and J11
• COM: one 8-pin, RJ-45 connector, J9
CP6002-R1-MC and CP6002-R2-MC:
• USB: two 4-pin, type A connectors, J6 and J7
• Ethernet: one 8-pin, RJ-45 connector, J10
• DisplayPort: one 20-pin DisplayPort connector, J8
Onboard Connectors CP6002-R1:
• PMC/XMC Slot A: Four PMC connectors, J25 - J28 (Jn1 - Jn4)
• PMC/XMC Slot A: One XMC connector, J24 (P15)
• One 12-pin SATA extension connector, J19, for CP6001-EXT-SATA
• One 34-pin extension connector, J18, for SATA Flash module (SSD)
• JTAG connector, J15
• Extension connector, J14
• XDP-SFF (debug) connector, J30
• CompactFlash socket, J16
• CompactPCI Connectors J1 - J5
• Hot Swap connector J13
CP6002-R1-MC and CP6002-R2-MC:
• PMC/XMC Slot A: Four PMC connectors, J25 - J28 (Jn1 - Jn4)
• PMC/XMC Slot B: Three PMC connectors, J21 - J23 (Jn1 - Jn3)
• PMC/XMC Slot A: One XMC connector, J24 (P15)
• PMC/XMC Slot B: One XMC connector, J20 (P15)
• One 34-pin extension connector, J18, for SATA Flash module (SSD)
• JTAG connector, J15
• Extension connector, J14
• XDP-SFF (debug) connector, J30
• CompactFlash socket, J16 (CP6002-R1-MC)
• CompactPCI Connectors J1 - J5
• Hot Swap connector J13
Table 1-2: CP6002 Main Specifications (Continued)
FEATURES SPECIFICATIONS