Kontron CP6002 - Manual (Page 34)

Introduction CP6002
Page 1 - 14 ID 1036-6431, Rev. 3.0
P R E L I M I N A R Y
Interfaces
Hot Swap Compatible The CP6002 supports System Master hot swap functionality and application-
dependent hot swap functionality when used in a peripheral slot.
When used as a System Master, the CP6002 supports individual clocks for
each slot and the ENUM signal handling is in compliance with the PICMG 2.1
Hot Swap Specification.
Gigabit Ethernet
Up to four 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
based on up to four Intel® 82574L Ethernet PCI Express bus controllers:
• Up to two RJ-45 connectors on the front panel
• Two ports on the rear I/O (PICMG 2.16)
• Automatic mode recognition (Auto-Negotiation)
• Automatic cabling configuration recognition (Auto-MDI/X)
USB
Six USB ports supporting UHCI and EHCI:
• Two type A USB 2.0 connectors on the front panel
• Four USB 2.0 ports on the rear I/O interface
Serial Two 16C550-compatible UARTs (RS-232/RS-422 signaling):
• One RS-232 port on the front panel and routed to rear I/O, COM1
• One RS-422 port on the rear I/O, COM2
PMC Up to two PMC slots:
• Onboard mezzanine connectors for standard PMC modules:
• Four connectors for PMC / XMC slot A (Jn1-Jn4)
• Three connectors for PMC / XMC slot B (Jn1-Jn3), optional
• Up to 64-bit / 66 MHz PCI or up to 64-bit / 100 MHz PCI-X interface with
dedicated PCIe-to-PCI-X bridge
• Only 3.3V PCI signaling voltage
• Rear I/O supported through the CompactPCI connector J4 (slot A)
• Supported voltages: 3.3 V, 5 V, +12 V, and -12 V
XMC Up to two XMC slots:
• One onboard XMC connector (P15) for PMC / XMC Slot A
• One onboard XMC connector (P15) for PMC / XMC Slot B, optional
• Up to x8 lanes PCI Express per XMC slot
• Rear I/O supported through the PMC connector (Jn4) to the
CompactPCI connector J4 (slot A)
Keyboard and Mouse Keyboard and mouse are supported:
• USB support
Table 1-2: CP6002 Main Specifications (Continued)
FEATURES SPECIFICATIONS