Kontron JRexplus-DC - Manual (Page 16)

KTD-S0008-F Page 11 Getting Started
JRexplus-DC User's Guide
Fans usually shipped with KONTRON Technology A/S products have 50,000-hour typical operating life. The
above estimates assume no fan, but a passive heat sinking arrangement. Estimated RTC battery life (as
opposed to battery failures) is not accounted for in the above figure and needs to be considered for
separately. Battery life depends on both temperature and operating conditions. When the Kontron unit has
external power; the only battery drain is from leakage paths.
All data is for information purposes only and not guaranteed for legal purposes. Subject to change without
notice. Information in this datasheet has been carefully checked and is believed to be accurate; however,
no responsibility is assumed for inaccuracies.
4 Getting Started
Getting started with the JRexplus-DC is very easy. Take the following steps:
Connect the ATX-adapter (KAB-ATX-10) or the delivered 5V adapter (KAB-ADAPT-ATXto5V) to
the JRexplus-DC 10pin ATX power connector J35. The location of connector J35 can be found
in the Appendix B.
Plug a suitable DDR2-SDRAM memory module into the RAM socket.
Connect a DVI monitor to the DVI connector (the use of a VGA monitor with a DVItoVGA
adapter is also possible).
Plug a keyboard and/or mouse to the PS/2 or USB connector(s).
Plug a Compact Flash card into the CF socket on the bottom of the board.
Connect an ATX power supply
Make sure all your connections have been made correctly. Turn on the power by shortening
the power button pins on the Front Panel Pin Header 1 (J36).
Enter the BIOS by pressing the Del key during boot-up. Make all changes in the BIOS Setup.
See the BIOS Setup chapter of this manual for details.