La-Z-Boy SlumberAir Mattress System - Manual (Page 6)

11 10
SlumberAir ™ Mattress System Additional
Feature and Troubleshooting
ADDITIONAL FEATURE:
The sleep sofa includes a television viewing headrest position. To raise the headrest, stand to the side of the
sleep sofa and pull the head portion of the sleeper mechanism upward. Lift upward again to release the
locking mechanism and lower the headrest back down to its original position.
TROUBLESHOOTING FOR THE SLUMBERAIR ™ MATTRESS SYSTEM:
If you experience difficulty inflating your mattress, please follow these easy steps:
1. If the mattress is not inflating, make sure that the release valve is closed and securely locked into place.
If the valve is open, push down on the outer rim of the valve with your thumbs until the valve tab locks, or
“snaps”, into place, sealing the valve. Do not push on the middle of the valve and avoid pushing the valve
to the side, damage may occur.
2. If the valve is leaking, open the release valve and carefully remove the soft clear gasket from the valve
cover. Rinse the gasket in warm water and towel dry. Reinsert the gasket into the valve cover. Make sure
that the groove in the gasket is toward the valve cover. Leave the valve open for approximately 30 minutes.
Close the release valve, so that it is securely locked into place, and proceed to inflate the mattress.
If the mattress still does not inflate, contact your La-Z-Boy ® dealer for instructions on returning it
for examination and repair.
NOTE: There are no user maintenance or repair requirements for the SlumberAir ™ mattress pump.
SlumberAir ™ Mattress Pump Specifications:
Input: AC120V 60Hz 1.1A
The motor is equipped with an internal on/off switch
and automatic air pressure bypass.
Notes: