Mercedes-Benz GL-Class 2015 - Manual (Page 434)

R Do not use wooden blocks or similar
objects as a jack underlay. Otherwise, the
jack will not be able to achieve its load-
bearing capacity due to the restricted
height.
R Make sure that the distance between the
underside of the tires and the ground does
not exceed 1.2 in (3 cm).
R Do not place your hands or feet under the
raised vehicle.
R
Do not lie under the vehicle.
R
Do not start the engine when the vehicle is
raised.
R Never open or close a door or the tailgate
when the vehicle is raised.
R
Make sure that no persons are present in
the vehicle when the vehicle is raised.
X Using lug wrench :, loosen the bolts on
the wheel you wish to change by about one
full turn. Do not unscrew the bolts com-
pletely.
The jacking points are located just behind the
front wheel housings and just in front of the
rear wheel housings (arrows).
X Take the ratchet wrench out of the vehicle
tool kit and place it on the hexagon nut of
the jack so that the letters AUF are visible.
; Jacking point
= Jack
? Crank
X
Position jack = at jacking point ;.
The alignment bolt on the jack must be
inserted into the intended opening on the
jacking point.
Example
X Make sure the foot of the jack is directly
beneath the jacking point.
X
Turn ratchet wrench ? until jack = sits
completely on jacking point ; and the
base of the jack lies evenly on the ground.
X Turn ratchet wrench ? until the tire is
raised a maximum of 1.2 in (3 cm) from the
ground.
432
Changing a wheel
Wh
eels
an
d
tire
s