Hazard warning flasher, Headlamp cleaning system, Controls in detail – Mercedes-Benz CLS-Class 2009 Owners Manual User Manual
Page 100
Lighting
98
Turn signals
1
Turn signals, right
2
Turn signals, left
X
Press the combination switch in direction
of arrow
1
or
2
.
The corresponding turn signal indicator
lamp
L
or
K
in the instrument clus-
ter flashes.
The combination switch resets automatically
after major steering wheel movements.
i
To signal minor directional changes such
as changing lanes, press combination
switch only to point of resistance and
release. The corresponding turn signal
lamps will flash three times.
The hazard warning flasher can be switched
on at all times, even with the SmartKey
removed from the starter switch or with the
SmartKey with KEYLESS-GO removed from
the vehicle.
The hazard warning flasher comes on auto-
matically when an air bag deploys.
The hazard warning flasher switch is located
on the center console.
1
Hazard warning flasher switch
X
Switching on: Press hazard warning
flasher switch
1
.
All turn signal lamps are flashing.
i
With the hazard warning flasher activated
and the combination switch set for either
left or right turn, only the respective left or
right turn signals will operate when the igni-
tion is switched on.
X
Switching off: Press hazard warning
flasher switch
1
again.
i
If the hazard warning flasher has been
activated automatically, press hazard
warning flasher switch
1
once to switch
off.
With the engine running the headlamps will
automatically be cleaned with a high-pres-
sure water jet when you have
R
switched on the headlamps
and
R
the windshield wipers have wiped the wind-
shield with washer fluid five times
When you switch off the ignition, the counter
resets.
For information on filling up the washer res-
ervoir, see “Washer system and headlamp
cleaning system” (
Controls in detail