Mercedes-Benz CLS-Class 2009 Owners Manual - Manual (Page 142)

Control system
140
Distance to empty
X Press button ÿ or è repeatedly until
the first function of the Trip computer
menu appears in the multifunction display.
X Press button j or k repeatedly until
the message Range: appears in the multi-
function display.
The calculated remaining driving range
based on the current fuel tank level
appears in the multifunction display.
If only very little fuel is left in the tank, a
vehicle at the fuel pump
¿ is shown
instead of the range.
Telephone menu
G Warning!
A driver’s attention to the road must always
be his/her primary focus when driving. For
your safety and the safety of others, we
recommend that you pull over to a safe
location and stop before placing or taking
a telephone call. If you choose to use the
telephone while driving, please use the
hands-free device and only use the tele-
phone when weather, road and traffic con-
ditions permit.
Some jurisdictions prohibit the driver from
using a mobile phone while driving a vehi-
cle.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approxi-
mately 14 m) every second.
Never operate radio transmitters equipped
with a built-in or attached antenna (i.e.
without being connected to an external
antenna) from inside the vehicle while the
engine is running. Doing so could lead to a
malfunction of the vehicle’s electronic sys-
tem, possibly resulting in an accident and/
or personal injury.
You can connect your telephone via Blue-
tooth
® to the COMAND system, see separate
COMAND system operating instructions.
X Switch on the COMAND system.
See separate COMAND system operating
instructions.
X Press button ÿ or è on the multi-
function steering wheel repeatedly until the
message TEL appears in the multifunction
display.
One of the following messages will appear
in the multifunction display:
R
No Service: No network is available.
R Bluetooth Ready: The telephone has
not been connected to the COMAND sys-
tem via Bluetooth
® yet.
X Connect the telephone to the
COMAND system via Bluetooth
® .
R Ready or name of the network provider
(if available): The telephone has found a
network and is ready for use. You can
operate it using the control system.
Controls in detail