Mercedes-Benz G-Class 2009 Owners Manual - Manual (Page 226)

X Remove edge protection : in direction of
arrow ;.
i Before removing side trim panel =
completely, the electrical connectors must
be disconnected.
X Pull off side trim panel = in direction of
arrow ? so the electrical connectors are
accessible.
X Disconnect electrical connectors.
X Remove side trim panel = completely.
A
Socket wrench
X Take the tool bag out of its storage
compartment (
Y page 194).
X Take socket wrench A out of the tool bag.
X Closing/raising: Turn socket wrench A
clockwise.
X Opening/lowering: Turn socket wrench
A counterclockwise.
X Connect electrical connectors.
X Reinstall side trim panel =.
Shackles B in side trim panel = must be
hooked in side wall C.
X Reinstall edge protection :.
X Close the tailgate.
X Store the tool bag with the vehicle tools in
the designated storage compartment.
Brush guard
G Warning!
The brush guard is designed solely to enhance
the appearance of the vehicle and help
protect grille and headlights from minor
mishaps, either on- or off road.
Since the safety characteristics are limited in
the event of an accident, brush guard are not
intended to prevent injury or damage in the
event of an accident. Also check state and
local regulations on installation and use.
Raise and lower brush guard in an open space
with plenty of room.
i Only lower brush guard to clean
headlamps.
224
Brush guard
Practical hints
463_AKB; 2; 52, en-US
d2ureepe,
Version: 2.11.7.1
2008-12-02T10:52:11+01:00 - Seite 224