Mercedes-Benz G-Class 2009 Owners Manual - Manual (Page 232)

X Insert the bulb socket back into side
marker lamp housing ;.
X Reinstall dust cover =.
X Reinstall side marker lamp housing ;.
X Install and tighten securing screws :.
i Do not overtighten securing screws :.
Otherwise side marker lamp housing ;
could be damaged.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following:
X Switch off the ignition.
X Turn the exterior lamp switch to position
$.
Removing/installing rear lamp guard
(G 55 AMG only)
X Remove screws ;.
X Swivel rear lamp guard : outward. Make
sure the guard does not strike painted
surfaces.
X Swivel rear lamp guard : back after
replacing bulbs and fasten it with
screws ;.
Tail lamp unit
X G 55 AMG only: Remove the rear lamp
guard.
Example illustration: Left tail lamp lens (right tail
lamp lens laterally reversed)
X Loosen and remove securing screws :.
X Remove tail lamp lens ;.
Example illustration: Left tail lamp unit (right tail
lamp unit laterally reversed)
=
Turn signal lamp bulb
? Brake, tail, parking and standing lamp
bulb
A
Tail, parking and standing lamp bulb
X Gently press onto respective bulb =, ?,
or A and turn counterclockwise out of its
bulb socket.
X Gently press the new bulb into the bulb
socket and turn clockwise until it engages.
X Reinstall tail lamp lens ;.
X Install and tighten securing screws :.
230
Replacing bulbs
Practical hints
463_AKB; 2; 52, en-US
d2ureepe,
Version: 2.11.7.1
2008-12-02T10:52:11+01:00 - Seite 230