Mercedes-Benz CLK-Class 2008 Owners Manual User Manual
Page 457
456
Practical hints
Flat tire
̈
After attaining a tire inflation pressure
of 26 psi (1.8 bar), press 0 on electric
air pump switch
3 (
The electric air pump is switched off.
̈
Turn the SmartKey in the starter switch
to position 0 (
Vehicles with KEYLESS-GO*:
̈
Press the KEYLESS-GO* start/stop
button (
page 40) on the gear
selector lever twice. Do not depress
brake pedal.
̈
Detach the electric air pump.
The air hose may still be hot. Please
exercise appropriate caution.
̈
Place the electrical air pump back in
the trunk.
̈
Close the trunk.
̈
Drive off immediately.
The TIREFIT sealant will distribute itself
evenly inside the tire.
̈
After driving the vehicle for an initial
10 minutes, check the tire inflation
pressure using pressure gauge
b on
the air pump.
Warning!
G
If a tire inflation pressure of 26 psi (1.8 bar)
is not attained, the tire is too severely
damaged for TIREFIT to provide a reliable
tire repair.
In this case, TIREFIT cannot properly seal
the tire.
Do not drive the vehicle.
Contact the nearest Mercedes-Benz Center
or call Roadside Assistance.
Warning!
G
Do not exceed vehicle speed of
50 mph (80 km/h). A TIREFIT repair is not
designed to operate at higher speeds.
The sticker must be attached on the instru-
ment cluster where it will be easily seen by
the driver.
Vehicle handling characteristics of a TIREFIT
repaired tire may change. Adapt your driving
accordingly.
୴୴