Mercedes-Benz CLK-Coupe 2007 Owners Manual - Manual (Page 53)

52
Getting started
Driving
KEYLESS-GO start/stop button
1 USA only
2 Canada only
̈ Press KEYLESS-GO start/stop button
once.
The engine starts if the SmartKey with
KEYLESS-GO is in the vehicle.
For information on turning off the engine
with KEYLESS-GO, see “Turning off the en-
gine with KEYLESS-GO*” (
୴ page 61).
Starting difficulties
If the SmartKey is left in starter switch
position 0 for an extended period of time,
it can no longer be turned in the switch. In
this case, the steering is locked.
̈ To unlock, remove SmartKey from
starter switch and reinsert.
If the engine does not start as described,
carry out the following steps:
̈ If you are starting the engine with the
SmartKey, turn SmartKey in starter
switch to position 0 and repeat starting
procedure.
̈ If you are starting the engine with
KEYLESS-GO*: Close any doors that
may be open to allow for better detec-
tion of the SmartKey with
KEYLESS-GO*.
Or:
Start the engine with the SmartKey as
radio signals from another source may
be interfering with the SmartKey with
KEYLESS-GO*.
̈ Repeat the starting procedure
(
୴ page 50).
Remember that extended starting at-
tempts can drain the battery.
̈ Get a jump start ( ୴ page 425).
If the engine does not start after several
starting attempts, there could be a mal-
function in the engine electronics or in the
fuel supply system.
̈ Notify an authorized Mercedes-Benz
Center.
୴୴