Oldcastle BuildingEnvelope Signature Series Unit Wall - Manual (Page 7)

July 2013 06-Locate-Install-Anchors 1-866-Oldcastle (653-2278) www.oldcastlebe.com
LOCATE AND INSTALL ANCHORS
1. LOCATE AND INSTALL ANCHORS
See approved shop drawings for anchor types and locations.
Locate centerline of aluminum anchor at the mark for centerline of mullion.
Adjust alum anchor bracket for in and out. Apply aluminum serrated washers. Make final in and out
adjustment prior to tightening the anchor bolt in place.
2 1/2"
±1" building tolerances
3 1/2" slot
for in/out adjustments
Mullion/anchor
centerline
Face of slab/beam
Back of mullion
Face of slab/beam
Back of mullion
SIGNATURE SERIES UNIT WALL INSTALLATION MANUAL
Location of this point
is CRITICAL! Field survey
may be required
Reference shop drawings for
actual anchor configuration
and/or project specific
information.
Anchor bolt (ref. shop drawings
for specific fastener info/torque
requirements)
Alum anchor bracket
Alum serrated washer
Reference field conditions.
Isolator required to prevent
galvanic reaction.